Please review the entire description and the technical specifications below the description for the most accurate information on this item. We are a liquidation center so most if not all of our items have torn or missing original packaging. We use the "New Other" category because, to our knowledge, the items are new unless otherwise specified in the description but may have have some imperfections. Please contact us before purchasing if you have any questions.
This is a Sandpiper centrifugal pump. It is powered by 2-1/2 horse power (HP) and the motor RPM is 3000. The inlet is 1/2 of an inch NPTF and the air inlet pressure is 80 pounds per square inch (PSI). The gallons per minute (GPM) of water at 5 feet of head is 300. The maximum head is 55 feet and the maximum liquid temperature is 160 degrees fahrenheit. The diameter is 13 inches and the discharge NPT is 3 inches F. The maximum diameter of solids is 1-1/2 inches. The overall length is 13 inches, the overall width is 12-1/5 inches, and the overall height is 23-1/2 inches.
We have inspected this item and we do not have the proper equipment to fully test it. There are some slight dents around the base of the unit. It appears to have some fluid/lubricant that has leaked onto the unit. There are also some cosmetic scuffs and scratches around the unit. Please refer to the photos for more information.
|Air Inlet Pressure (PSI)||80|
|GPM of Water @ 5 Ft. of Head||300|
|GPM of Water @ 10 Ft. of Head||275|
|GPM of Water @ 15 Ft. of Head||240|
|GPM of Water @ 20 Ft. of Head||210|
|GPM of Water @ 25 Ft. of Head||175|
|GPM of Water @ 30 Ft. of Head||150|
|GPM of Water @ 35 Ft. of Head||125|
|GPM of Water @ 40 Ft. of Head||100|
|GPM of Water @ 45 Ft. of Head||70|
|GPM of Water @ 50 Ft. of Head||25|
|GPM of Water @ 55 Ft. of Head||0|
|GPM of Water @ 60 Ft. of Head||36|
|Impeller Material||Cast Iron|
|Max. Head||55 ft.|
|Max. Liquid Temp.||160 Degrees F|
|Discharge NPT||3" F|
|Max. Dia. Solids||1-1/2"|
|Shaft Seal||Buna N|
We do not offer a warranty for any of our products.